JVC DM-NC40, Инструкция по эксплуатации

Страница: 42 / 60

42
<Connected party> Teleconference mode
1.
Set the power to ON.
4.
The sent number will flash.
Press the PLAY button.
(Connection will not be established unless
this button is pressed.)
<User> Teleconference mode
1.
Set the power to ON.
2.
Enter the number of the party to connect
(number registered in Edit No. of
TELEPHONE BOOK screen).
3.
Press the PLAY button.
Connected party
2 -
In the Teleconference mode, both videos of teleconference can be displayed on a single
monitor by PinP.
Operating the Teleconference System
Number display
POWER IN 2 IN 1 HOLD DECODE ENCODE
CF PLAY STOP HOLD SELECT P P in
POWER IN 2 IN 1 HOLD DECODE ENCODE
CF PLAY STOP HOLD SELECT P P in
Network
Network
4.7. 6. 1.
User
Number display
2. 3.7. 6. 1.
The number display circles, IP address is displayed as shown
on page 48, and then turns off when ready.
(Off)
The number display circles, IP address is displayed as shown
on page 48, and then turns off when ready.
(Off)
• Use
왗
and
왘
to select the digit to
input.
• Use
왔
and
왖
to increment/decre-
ment the number of the selected
digit (0~9).
Memo
• Pressing
왗
or
왘
first will display the number of
the previous connection.
The entered number will flash.
The sent number will flash.
For automatic connection without pressing the PLAY
button, set Acceptance in the NETWORK SETUP
screen to Auto.
“HHH” will be displayed if the party is not regis-
tered in TELEPHONE BOOK.