Juniper SRX550, Руководство по оборудованию

Страница: 105 / 220

Organizing Interface Cables on the SRX550 Services Gateway | 79
SRX550 Services Gateway General Safety Guidelines and Warnings
Connecting an AC Power Cord to the SRX550 Services Gateway
To connect the AC power cord:
1. Locate a replacement power cord with the type of plug appropriate for your geographical location.
2. Connect the power cord to the power supply, as shown in Figure 23 on page 89 .
Figure 23: Connecting an AC Power Cord on the SRX550 Services Gateway
3. Insert the power cord plug into an external AC power source receptacle.
4. Route the power cord along the cable restraint toward the left or right corner of the chassis. If they
are needed to hold the power cord in place, thread plastic cable ties, which you must provide, through
the openings on the cable restraint.
5. Verify that the power cord does not block the air exhaust and access to services gateway components,
or drape where people could trip on it. If the power supply is correctly installed and functioning normally,
the POWER LED lights steadily.
89