Juniper PTX5000, Руководство по оборудованию

Страница: 599 / 721

SIB 4 Junction 75 80 90 85 105 95 115
SIB 5 Exhaust 60 65 78 75 85 80 95
SIB 5 Junction 75 80 90 85 105 95 115
SIB 6 Exhaust 60 65 78 75 85 80 95
SIB 6 Junction 75 80 90 85 105 95 115
SIB 7 Exhaust 60 65 78 75 85 80 95
SIB 7 Junction 75 80 90 85 105 95 115
SIB 8 Exhaust 60 65 78 75 85 80 95
SIB 8 Junction 75 80 90 85 105 95 115
5. Look at the PDU and PSM LEDs on the craft interface.
6. If both PDUs fail, the system temperature might have exceeded the threshold, causing the system to
shut down. If the temperature exceeds the acceptable maximum, the Control Board turns off the
PDUs.
7. Check the temperature of components that are monitored for temperature alarms by issuing the show
chassis environment monitored command. For more information about temperature alarms, see Table 87
on page 589 .
Verify that the status of each component is OK .
NOTE:
Exhaust A
,
Exhaust B
,
TL n
,
TQ n
,
Ambient
,
Exhaust
, and
Junction
correspond to temperature
sensors located on the respective hardware component.
The output is similar to the following:
user@host> show chassis environment monitored
Class Item Status Measurement
Routing Engine 0 CPU OK 69 degrees C / 156 degrees F
Routing Engine 1 CPU OK 60 degrees C / 140 degrees F
CB 0 Exhaust A OK 44 degrees C / 111 degrees F
CB 0 Exhaust B OK 40 degrees C / 104 degrees F
CB 1 Exhaust A OK 38 degrees C / 100 degrees F
CB 1 Exhaust B OK 35 degrees C / 95 degrees F
SIB 0 Exhaust OK 36 degrees C / 96 degrees F
SIB 0 Junction OK 40 degrees C / 104 degrees F
581