Juniper JUNOSE 11.2.X MULTICAST ROUTING, Руководство по настройке

Страница: 88 / 256

•
DSU mode—Mode of the fractional T3 lines: Digital Link mode or Larscom mode
•
DSU bandwidth—Speed of the fractional T3 lines
•
DSU scramble—Status of scrambling for fractional T3: on or off
•
MDL Transmit Path—Indicates whether the transmission is active or not active (T3
only)
•
MDL Transmit Test-Signal—Indicates if the transmission is active or not active (T3
only)
•
MDL Transmit Idle-Signal—Indicates if the transmission is active or not active (T3
only)
•
Equipment Identification Code—eic string for MDL (T3 only)
•
Line Identification Code—lic string for MDL (T3 only)
•
Frame Identification Code—fic string for MDL (T3 only)
•
Facility Identification Code—fic string for MDL (T3 only)
•
Equipment Port—port string for MDL (T3 only)
•
Unit Identification Code—unit string for MDL (T3 only)
•
Facility Identification Code—pfi string for MDL (T3 only)
•
Port Code—port string for MDL (T3 only)
•
Generator Number—generator string for MDL (T3 only)
•
BERT test—Number of current test and total number of tests (T3 only)
•
Test interval—Length of the BERT test
•
status—Sync (controller is synchronized with remote device) or NoSync (controller
is not synchronized with remote device)
•
Sync count—Number of times the pattern detector synchronized with the incoming
data pattern
•
Received bit count—Number of bits received
•
Error bit count—Number of bits with errors
•
Number of valid intervals—Number of 15-minute intervals since the T3 or E3 module
was last powered on or reset
•
Time elapse in current interval—Number of seconds that have passed in the 15-minute
(900 second) interval
•
Errored seconds—Number of errored seconds encountered by an E3 (not applicable
for T3) in the current interval (this field is not present for T3 controllers)
Copyright © 2010, Juniper Networks, Inc. 66
JunosE 11.2.x Physical Layer Configuration Guide