Juniper JUNOSE 11.2.X MULTICAST ROUTING, Руководство по настройке

Страница: 59 / 256

•
ifOperUp—Interface is functioning
•
ifOperTesting—Interface is being tested
•
ifOperNotPresent—Module has been removed from the chassis
•
ifOperDown—Interface is not functioning
•
snmp trap link-status of SNMP trapping (enabled or disabled)
•
Ds0 time slot map—Fractional T1 subchannel
•
Ds0 mode—Base data rate: either Nx56 or Nx64
•
The ft1 option displays the state of the serial interface.
•
The optional slot and port parameters display information about a specific slot and
port.
•
Example
host1# show controllers t3 ft1
Ft1 Interface at 2/0:1/1
Description: toronto ft1 interface
ifOperStatus = ifOperLowerLayerDown
snmp trap link-status = disabled
Ds0 time slot map = 0x1
Ds0 mode = Nx64
•
See show controllers t3.
show controllers t3 remote
•
Use to display MIB statistics for the remote end of a channelized T3 interface configured
for MDL or for the remote end of a T1 channel configured for FDL.
•
Specify the all option to display detailed information for all 15-minute intervals.
•
For definitions of the MIB statistics for a T3 interface, see RFC 2496—Definitions of
Managed Objects for the DS3/E3 Interface Types (January 1999).
•
For definitions of the MIB statistics for a T1 channel, see RFC 2495—Definitions of
Managed Objects for the DS1, E1, DS2 and E2 Interface Types (January 1999).
•
Field descriptions for a T3 interface
•
Far End MDL Carrier bit—Status of MDL configuration on remote device connected
to T3 interface
•
set—MDL is configured for carrier mode
•
not set—MDL is not configured for carrier mode
•
Far End Equipment Identification Code—eic string sent by remote device for MDL
•
Far End Line Identification Code—lic string sent by remote device for MDL
•
Far End Frame Identification Code—fic string sent by remote device for MDL
37 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring Channelized T3 Interfaces