Juniper JUNOSE 11.2.X MULTICAST ROUTING, Руководство по настройке

Страница: 224 / 256

•
Primary/Secondary link signal detected, Primary/Secondary link signal not
detected—Specifies the port (primary or secondary) on which the router detects a
signal (not displayed on GE I/O modules that do not support SFPs)
•
5 minute input rate—Data rates based on the traffic received in the last 5 minutes
•
5 minute output rate—Data rates based on the traffic sent in the last 5 minutes
•
In—Analysis of inbound traffic on this interface
•
Bytes—Number of bytes received in error-free packets
•
Unicast—Number of unicast packets received
•
Multicast—Number of multicast packets received
•
Broadcast—Number of broadcast packets received
•
Errors—Total number of errors in all received packets; some packets might contain
more than one error
•
Discards—Total number of discarded incoming packets
•
Mac Errors—Number of incoming packets discarded because of MAC sublayer
failures
•
Alignment—Number of incomplete octets received
•
CRC—Number of packets discarded because the checksum that the router
computed from the data does not match the checksum generated by the originating
devices
•
Too Longs—Number of packets discarded because the size exceeded the MTU
•
Symbol Errors—Number of symbols received that the router did not correctly
decode
•
Out—Analysis of outbound traffic on this interface
•
Bytes—Number of bytes sent
•
Unicast—Number of unicast packets sent
•
Multicast—Number of multicast packets sent
•
Broadcast—Number of broadcast packets sent
•
Errors—Total number of errors in all transmitted packets; note that some packets
might contain more than one error
•
Discards—Total number of discarded outgoing packets
•
Mac Errors—Number of outgoing packets discarded because of MAC sublayer
failures
Copyright © 2010, Juniper Networks, Inc. 202
JunosE 11.2.x Physical Layer Configuration Guide