Juniper JUNOSE 11.2.X MULTICAST ROUTING, Руководство по настройке

Страница: 172 / 256

•
Operational Status—Physical state of the interface:
•
up—Interface is operational
•
down, failure alarm—Interface is not operational; type of defect that caused failure
is specified
•
time since last status change—Time since the line module was rebooted
•
Loopback State—Type of loopback configured at this layer in the interface, or none
•
Last Remote Loopback Request Sent
•
BERT test—Number of current test and total number of tests
•
Test interval—Length of the BERT test
•
status—Sync (controller is synchronized with remote device) or NoSync (controller
is not synchronized with remote device
•
Sync count—Number of times the pattern detector synchronized with the incoming
data pattern
•
Received bit count—Number of bits received
•
Error bit count—Number of bits with errors
•
Mode—Type of interface: SONET or SDH
•
Timing source—Type of clock source configured for the channel:
•
internal module—Internal clock is from the line module itself
•
chassis—Internal clock is from the configured router clock
•
Current section alarms—Number of suspect bit patterns found in several consecutive
frames in section layer, or none
•
Current line alarms—Number of suspect bit patterns found in several consecutive
frames in line layer
•
Channel configuration—Parameters for specific controllers; the actual parameters
depend on the controller.
•
ifAdminStatus—State of the controller in the software configuration: up or down
•
ifOperStatus—Physical state of the controller: up or down
•
Time since last status change—Time the controller has been up or down
•
Alarms—Number of suspect bit patterns found in several consecutive frames
•
snmp trap link-status—State of SNMP link status processing for the controller:
enabled or disabled
Copyright © 2010, Juniper Networks, Inc. 150
JunosE 11.2.x Physical Layer Configuration Guide