Errata
61
Release 10.3.2
The
Configuring VRRP
section in
JunosE System Basics Configuration Guide,
Chapter 1, Planning Your Network
and the
Before You Configure IP
section in
JunosE IP, IPv6, and IGP Configuration Guide, Chapter 1, Configuring IP
erroneously refer to the
JunosE IP Services Configuration Guide.
These references
are corrected to refer to the
JunosE Service Availability Configuration Guide.
The
Detecting Corrupt File Configurations
section in
JunosE System Basics
Configuration Guide, Chapter 5, Managing the System
fails to mention that if you
check the running configuration for corruption manually when auto mode is
enabled, a warning message appears:
host1(config)#
service check-config running-configuration
WARNING: This command will cause config monitor to switch into manual mode.
Proceed with current command? [confirm]
If you confirm you want to check the running configuration in manual mode or
ignore the warning message, then manual mode is enabled.
In
JunosE IP, IPv6
,
and
IGP Configuration Guide, Chapter 2, Configuring IPv6
, the
Before You Configure
IPv6
section fails to list all the modules that support IPv6.
You can find complete lists of modules that support IPv6 in the following
appendixes:
E120 and E320 Module Guide, Appendix A, IOA Protocol Support
ERX Module Guide, Appendix A, Module Protocol Support
In the
Monitoring IGMP
section in
JunosE Multicast Routing Configuration Guide,
Chapter 2, Configuring IGMP
, the bulleted list of field descriptions and output
example for the
show ip igmp interface
command incorrectly display the field
name for the number of multicast groups that the interface has discovered as
"Groups learned". The correct label for this field is "Groups learnt".
In the
Configuring Graceful Restart
section in
JunosE IP, IPv6, and IGP
Configuration Guide, Chapter 6, Configuring IS-IS
, the default time for the
restarting router to wait for the LSP database to synchronize and to reset the
overload bit is incorrectly mentioned as 30 seconds. The correct value is 100
seconds for both the instances.
In the
JunosE Service Availability Configuration Guide
for Releases 10.3.0, 11.0.0,
and 11.1.0, the Notes column for the Multicast Routing rows under IPv4
Multicast Routing and under IPv6 Multicast Routing in the
Application Support
for Stateful SRP Switchover
table of
Chapter 3, Managing Stateful SRP Switchover
,
stated incorrectly that only static recovery is supported. The correct
information is as follows:
Stateful SRP switchover. During switchover, the system mirrors the multicast
queue so that IP can use the same queue without needing to recreate a different
connection. The multicast queues are also preserved during the switchover and
graceful restart period to ensure that multicast data continues to be forwarded
using the previously learned multicast forwarding state.
NOTE:
Before JunosE Release 10.3.0, the
Application Support for Stateful SRP
Switchover
table was located in the
JunosE System Basics Configuration Guide
.
Содержание JUNOSe 10.3.2
Страница 8: ...viii Table of Contents JunosE 10 3 2 Release Notes ...
Страница 76: ...JunosE 10 3 2 Release Notes 68 Errata ...
