Juniper JUNOSe 10.3.2, Руководство по выпуску

Страница: 49 / 118

Known Problems and Limitations
„ 41
Release 10.3.2
„ If you saved the running configuration of the router as a script file (.scr) and
execute the script to apply the settings on the router, ICR partition configuration
commands in the .scr file might fail to add group members to the partition. This
problem happens when the subscriber configuration in the .scr file is placed
before the ICR partition configuration. However, this problem does not occur if
you used a system configuration (.cnf) file to set up the router. [Defect ID
183913]
Work-around : To correct this problem and enable ICR partitions to be created
correctly, make sure that you add the ICR partition configuration before the
subscriber interface configuration in the .scr file. You can perform this
reordering by modifying the .scr file to place the commands that configure
subinterfaces for ICR partitions before the commands used for VLAN-based or
S-VLAN-based grouping of subscribers.
IGMP
„ IGMPv3 proxy is not supported. [Defect ID 46038]
„ The E Series router IGMPv3 proxy does not operate correctly in the presence of
IGMPv2 queriers. [Defect ID 46039/46045]
Work-around: If an IGMPv2 router is present on the network, do not configure
version 3 with the ip igmp-proxy version command on that network interface.
(Version 2 is the default.)
„ The default value for the IGMPv3 proxy unsolicited report interval timer should
be 1 second rather than 10 seconds (the value for v2). [Defect ID 46040]
„ When more than about 100,000 mapped OIF entries are configured on a virtual
router, issuing the
no virtual router command for this and other virtual routers
does not delete all the virtual routers within the deletion timeout interval (3
minutes). The virtual routers do eventually delete after this timeout. [Defect ID
63882]
„ The E Series router does not log a warning when it receives an IGMPv2 query
but is not configured to use IGMPv2 on the interface. [Defect ID 46046]
IP
„ The ES2 4G LM can reset during a unified ISSU after you issue the issu start
command on a router configured with 8000 dynamic VCs and 8000
packet-triggered dynamic subscriber interfaces. [Defect ID 86761]
„ If you have a large configuration on a hybrid module combination (OC3/STM-1
GE/FE line module with the OC3-2 GE APS I/O module), boot from NVS, and
issue the
slot erase command before booting has completed, the line module
resets. [Defect ID 64104]
Work-around: To recover from the error, issue the slot reload command
anytime after the module begins to reset.