JUNOSe 10.2.2 Release Notes
52
Resolved Known Problems
When any of the subsystems is excluded for a JUNOSe release, a unified ISSU to
that release fails to apply conversion code to all of the line modules. As a result,
the line modules reset when they come up with that release. [Defect ID
179595]
Work-around:
To prevent the exclusion of a subsystem file from the release, do
the following before you upgrade to a new JUNOSe release that supports unified
ISSU:
1.
Issue the
show subsystems file
fileName
.rel
command, where
fileName
is
the name of the software release file, to determine whether any of the
subsystem files are excluded from the release.
2.
For each subsystem file that is excluded, issue the
no exclude-subsystem
subsystemName
command to remove the exclusion for the specified
subsystem file.
If you copied the software release to the router before removing the subsystem
file from the exclusion list, you must copy the release to the router again to
ensure that all subsystem files are included in the release.
Resolved Known Problems
The following problems were reported open in Release 10.2.1 and have been
resolved in this release, or have been resolved since the 10.2.1p0-2 patch release.
For more information about particular resolved problems, you can log in to the
JUNOSe Knowledge Base at https://www2.juniper.net/kb/, enter the defect ID
number in the Search by Keyword field, and click Search.
ATM
After upgrading, port showing “cannot get operational” status on aal5 interface
(hardware not present) [Defect ID 90068]
SRP module reset type: panic; file: apterLocation.cc; line: 179; task:
snmp_Data_1. [Defect ID 90202]
While doing HA switchover after ISSU with NBMA configuration, the OC3-4A
line card crashes. [Defect ID 184745]
DHCP
DhcpBasePlugIn::receivePacket() debugs displayed on line module for every
DHCP packet received. [Defect ID 89934]
SRP module reset type: panic, file: dhcpRelay.cc, task: dhcpRelay_dhcpRe, lr:
DhcpRelay::PbeSession::addClient [Defect ID 90261]
DoS Protection
The control-plane policer protocol configuration is misaligned after upgrade.
[Defect ID 89170]