JUNOSe 10.2.2 Release Notes
54
Errata
OSPF
After executing the
clear ipv6 ospf process
command, interfaces in the DOWN
state appear in the
show ipv6 ospf database
output. [Defect ID 90478]
OSPF adjacency might flap when ISSU is performed with OSPF default Hello
and Dead interval timers. [Defect ID 90562]
RIP
Problems with next hop in default RIP route advertisement. [Defect ID 90306]
RSVP-TE
SRP module reset type: processor exception 0x300 (read attempts) task:
rsvp_msgQueue_1 pc: 0x4d0547f0 -> Rsvp::doEndPointsChange [Defect ID
90246]
SRC Software and SDX Software
Problem with re-attaching policies on SDX managed DSI interfaces after a line
module reload. [Defect ID 87326]
SRP module reset type: processor exception 0x700 (program); task:
sssClient_Data_1 [Defect ID 89863]
On an ERX router configured for a LAG interface, the
show sae interfaces
and
the
show sae subscribers
command outputs display NasPortID as the interface
name of DSI interface created. [Defect ID 90208]
Errata
This section identifies errors found in the JUNOSe documentation. These errors are
corrected in subsequent releases of the affected documentation.
The Policy and QoS Maximums (for E120 and E320 routers) table in
JUNOSe
Release Notes
,
Appendix A, System Maximums
for Releases 9.x, 10.x, and 11.0.x
incorrectly states that the maximum number of policy classification (CLACL)
entries for the ES2 10G Uplink LM is 131,171.
The correct limit for CLACL entries for the ES2 10G Uplink LM in these releases
is 65,535.
The Link Layer Maximums table (for the E120 and E320 routers) in
Appendix A,
System Maximums
, of the
JUNOSe 10.2.0 Release Notes
, incorrectly refers to a
note for the maximum number of Ethernet S-VLANs per IOA for ES2 10G ADV
LMs. Although the entries in the table for the IOA combinations supported with
the ES2 10G ADV LM are correct, a note in this table section states that no more
than 16,384 S-VLANs are supported per LM. However, this limitation does not
apply to ES2 10G ADV LMs, which support a maximum of 32,768 S-VLANs per
LM.