JUNOSe 10.2.2 Release Notes
42
Known Problems and Limitations
If LSPs are announced into IS-IS, then the IS-IS routes cannot be used for
multicast RPF checks, because LSPs are unidirectional. [Defect ID 28526]
Work-around:
Configure static RPF routes with native hops when LSPs are
autoroute announced to IS-IS.
L2TP
After a unified ISSU completes on a router functioning as an L2TP access
concentrator (LAC), traffic outages occur on the L2TP network server
(LNS)-facing interface at the LAC in a configuration with 16,000 or 32,000 L2TP
sessions over 500 tunnels. [Defect ID 180147]
MLD
The E Series router MLDv2 proxy does not operate correctly in the presence of
MLDv1 queriers. [Defect ID 46039/46045]
Work-around:
If an MLDv1 router is present on the network, configure version
1 with the
ipv6 mld-proxy version
command on that network interface.
(Version 2 is the default.)
The default value for the MLDv2 proxy unsolicited report interval timer should
be 1 second rather than 10 seconds (the value for v1). [Defect ID 46040]
MLPPP
Failure to meet all of the following conditions for fragmented packets can result
in an incorrect operation during packet classification of the resulting
reassembled packet: [Defect ID 50111]
The initial fragment of a packet must either contain the entire MLPPP
packet or be greater than 128 bytes.
The fragment size of the peer must not be lower than 128 bytes.
The initial fragment of a packet must be larger than subsequent fragments
of that packet.
Mobile IP
The
@
realm
variable and the
@
keyword alone do not work for the
show ip
mobile binding
command. [Defect ID 178653]
Work-around
: You can use the
user
@
realm
syntax instead to display the
binding for a specific user, as in this example:
host1#
show ip mobile binding nai [email protected]
Alternatively, you can display the entire Mobile IP binding table by issuing the
show ip mobile binding
command without additional options.
