Jungheinrich ETVC 16, Руководство по эксплуатации

Страница: 53 / 89

1005
.G
B
E 20
5.4 Changing truck parameters
F
Changing of truck parameters will also change the driving behaviour of the truck. This
must be taken into account when commissioning the truck!
Parameters may only be changed while the truck is at a standstill and no lifting
movements are performed.
– Commission the truck (refer to section 3).
Insert key (738) into key switch and turn to the right until reaching the limit stop.
The display shows the user menu with vehicle name for about three seconds, after
that the battery charge and the service hours are indicated.
– Press the selection menu key (34).
The display shows „acceleration“ with the corresponding parameter.
– To view or change the truck parameters, proceed in accordance with the following
diagram.
– Moving between the 10 setting parameters is effected by means of the keys (32)
and (33).
1) L = Operating parameters are read out (Reading mode)
2) S = The chosen operational parameter can be modified (Writing mode)
3) Service hours display
4) Time display
5) Selection of parameters
6) Changing parameters
no
Acceleration
L
1)
Release brake
Change time
XX:XX
Inversion brake
Maximum speed
forward
Cut-back speed
forward
Maximum reversing
speed
Cut-back speed
reversing
Buzzer on/off
OFF
Acceleration
S
2)
Release brake
Change time
XX:XX
Inversion brake
Maximum speed
forward
Cut-back speed
forward
Maximum reversing
speed
Cut-back speed
reversing
Buzzer on/off
ON/OFF
Are you
sure?
yes
BATT xxx % xxh
3)
BATT xxx % xx:xx
4)
Default setting
“Travel” default values
Default setting
“Travel” default values
5) 6)
1005
.G
B
E 20
5.4 Changing truck parameters
F
Changing of truck parameters will also change the driving behaviour of the truck. This
must be taken into account when commissioning the truck!
Parameters may only be changed while the truck is at a standstill and no lifting
movements are performed.
– Commission the truck (refer to section 3).
Insert key (738) into key switch and turn to the right until reaching the limit stop.
The display shows the user menu with vehicle name for about three seconds, after
that the battery charge and the service hours are indicated.
– Press the selection menu key (34).
The display shows „acceleration“ with the corresponding parameter.
– To view or change the truck parameters, proceed in accordance with the following
diagram.
– Moving between the 10 setting parameters is effected by means of the keys (32)
and (33).
1) L = Operating parameters are read out (Reading mode)
2) S = The chosen operational parameter can be modified (Writing mode)
3) Service hours display
4) Time display
5) Selection of parameters
6) Changing parameters
no
Acceleration
L
1)
Release brake
Change time
XX:XX
Inversion brake
Maximum speed
forward
Cut-back speed
forward
Maximum reversing
speed
Cut-back speed
reversing
Buzzer on/off
OFF
Acceleration
S
2)
Release brake
Change time
XX:XX
Inversion brake
Maximum speed
forward
Cut-back speed
forward
Maximum reversing
speed
Cut-back speed
reversing
Buzzer on/off
ON/OFF
Are you
sure?
yes
BATT xxx % xxh
3)
BATT xxx % xx:xx
4)
Default setting
“Travel” default values
Default setting
“Travel” default values
5) 6)