Jungheinrich ETVC 16, Руководство по эксплуатации

Страница: 45 / 89

1005
.G
B
E 12
4.3 Adjusting the fork tines
F
To ensure safe picking up of loads, the
tines should be apart as far as possible
and set centrally to the truck. The load
centre must be located centrally bet-
ween the fork tines.
– Swivel the locking lever (22) upwards.
– Push the fork tines (23) along the fork
carrier (24) to the required position.
– Swivel the locking lever downwards
and deplace the fork until it engages a
groove.
4.4 Picking up and setting down loads
M
Before picking up a load, the driver has
to check that the load rests properly on
its pallet and that it does not exceed the
capacity of his truck.
– Pass the fork tines as far as possible
under the load.
Lifting
F
Persons must not be allowed to stand
under raised forks.
– Pull the solo-pilot (3) in the H direction.
Z
The inclination angle of the control lever
controls the lifting speed.
– Do not release the solo-pilot until the
desired lifting height has been rea-
ched.
Z
If the fork moves against the end stop
(audible noise emitted by the pressure
limiting valve), the multi-pilot stick must
immediately be returned to its neutral
position.
Lowering
– Push the solo-pilot (3) in the S direction.
Z
The inclination angle of the solo-pilot controls the lowering speed.
M
Avoid impacting of the load to prevent damage to the load and to the racking.
23
22
24
H
S
3
1005
.G
B
E 12
4.3 Adjusting the fork tines
F
To ensure safe picking up of loads, the
tines should be apart as far as possible
and set centrally to the truck. The load
centre must be located centrally bet-
ween the fork tines.
– Swivel the locking lever (22) upwards.
– Push the fork tines (23) along the fork
carrier (24) to the required position.
– Swivel the locking lever downwards
and deplace the fork until it engages a
groove.
4.4 Picking up and setting down loads
M
Before picking up a load, the driver has
to check that the load rests properly on
its pallet and that it does not exceed the
capacity of his truck.
– Pass the fork tines as far as possible
under the load.
Lifting
F
Persons must not be allowed to stand
under raised forks.
– Pull the solo-pilot (3) in the H direction.
Z
The inclination angle of the control lever
controls the lifting speed.
– Do not release the solo-pilot until the
desired lifting height has been rea-
ched.
Z
If the fork moves against the end stop
(audible noise emitted by the pressure
limiting valve), the multi-pilot stick must
immediately be returned to its neutral
position.
Lowering
– Push the solo-pilot (3) in the S direction.
Z
The inclination angle of the solo-pilot controls the lowering speed.
M
Avoid impacting of the load to prevent damage to the load and to the racking.
23
22
24
H
S
3