Jung WLAN-AC-POE-UAE, Продуктовая документация

Страница: 24 / 51

24
WLAN Access Point · Examples
- When used as a repeater, the signal strength of the signal to be amplified at the
installation site must be ≥ 70 dBm.
- With each ‘Repeating’, the signal cuts the data throughput and thus the overall
performance of your WLAN network to half. This has physical reasons and is not a
peculiarity of the WLAN Access Point !
Set up repeater function
General
• Install the WLAN Access Point correctly and in the correct position (installation
height 0.3 – 1.3 m) according to the installation instructions.
- After approx. one minute (after switching on) the device is ready for operation,
which is signalled by the function of the LED.
In order to be able to make the necessary settings for integration into the network, access
must be made directly to the device.
•
The programming of the repeater function is preferably done via the front
panel or via the network in order to avoid connection interruptions after the
changing of settings. It should not be done through WLAN!
The WLAN Access Point and the accessing device must be in the same IP address
range.
In repeater mode, the WLAN Access Point must record a WLAN signal and amplify it again.
For this purpose, a second transceiver unit (interface) is activated and programmed in the
WLAN Access Point.
Create and set up a new interface
• To do this, go to the menu Network > Wireless (see following figure).
• Click Add to create a new interface.
- A new interface is created as client (P) with the SSID ‘Jung’ (Q).
• Under Interface Configuration , change the mode to Client (RELAYED).
• Save this setting with the command
Save & Apply
.
Q
P