Art.-No.: 2095 LUX
Function:
Control output
Object
h
15
Function
On / Off
Name
Switching
Type
1-bit
DPT
1.001
Flag
C, W, T, -
Description
This object is always available in the operating mode "Brightness on-off
control", and in the operating mode "Constant light regulation" only if the
parameter "Start and end constant light regulation with" has been set to
"Switching telegram".
In brightness on-off control this object is used to output the switching
command to the lighting being controlled. The lighting is also switched via this
object in the operating modes "only automatic switch-on" and "only automatic
switch-off".
In constant light regulation this object is used to switch the lighting on or off
before the controller dims the actuator to the setpoint via Object 10.
This object should be linked with the "Switching" object of the actuators being
controlled (master and all slaves) using a group address.
Function:
Control input
Object
h
16
Function
Dimming value
Name
Status of actuator
dimming value
Type
1-byte
DPT
5.001
Flag
C, W, T, -
Description
This object is used to read the current dimming value from the dimming
actuator.
Note: The feedback object of the actuator linked with this must thus be
enabled for reading (set the "Read" flag!).
When the brightness control is switched on the control is started beginning
with this dimming value. If the object is not linked, the brightness control is
performed starting with the dimming value 0 %.
Page 17 of 27
Software "Brightness controller A01001"
Object table
