Art.-No.: 2095 LUX
value (600 lux), and is saved in the
device in non-volatile memory.
Setpoint in lux
(250 – 1600)
250...
600
...1600
This parameter is used to set the
brightness setpoint for the constant light
regulation.
This parameter is only visible if the
parameter "Setpoint as" is set to
"Parameter".
Maximum deviation
from the setpoint
15 lux
30 lux
45 lux
60 lux
This parameter determines how
precisely the desired setpoint is
adjusted. This is necessary because
control is performed using dimming
steps. Therefore when the maximum
deviation from the setpoint is too small it
may occur that in the event of a
"Brighter" control step the brightness is
already above the setpoint, and in the
event of a "Darker" control step the
brightness is already below the setpoint.
This leads to constant dimming up and
down, and thus to continuous brightness
fluctuations. If this is the case, the
permissible deviation from the setpoint
must be increased or the increment for
dimming (see the next parameter) must
be decreased.
Max. increment for
dimming
0.5 %
1 %
1.5 %
2 %
2.5 %
3 %
5 %
This parameter is used to set the
maximum "increment" for dimming (this
is the maximum value by which a new
dimming value can be larger or smaller
than the previous one).
Output dimming value
after
0.5 seconds
1 second
2 seconds
3 seconds
5 seconds
This parameter is used to define the wait
time between two dimming steps in
constant light regulation in master mode.
After a dimming step the time configured
here must elapse before an additional
dimming step can be transmitted. This
ensures that in constant light regulation
there are no abrupt brightness changes
that might be perceived as unpleasant
by the user of the room, even when the
actuator has short dimming times.
Start and end constant
light regulation with
Dimming value telegram
Switching telegram
This parameter is only visible if the
parameter "Operating mode" is set to
"Constant light regulation". This
parameter is used to define whether the
lighting should be switched on after
receipt of the telegram "Presence= ON"
(if the status was previously "Presence =
Page 22 of 27
Software "Brightness controller A01001"
Parameters
