Art.-No.: 2095 LUX
4.2.3 Object table
Number of communication objects:
17
Number of addresses (max):
100
Number of assignments (max):
120
Dynamic table management
No
Maximum table length
---
Function:
Enabling control
Object
h
0
Function
On / Off
Name
Presence
Type
1-bit
DPT
1.001
Flag
C, W, T, -
Description
This object can be linked with the on/off switching command transmitted by a
presence detector or presence button. This object is used to switch on or off
both the brightness control or constant light regulation, and at the same time
the automatic mode of the brightness controller (cf. object 1).
If the presence status = OFF and if a Presence = ON telegram is received, the
control and automatic mode are switched on. If, on the other hand, the
presence status = ON and an additional Presence = ON telegram is received,
then this does not change the status of the "Automatic mode" object (i.e. if
automatic mode is not enabled it remains disabled).
If the presence status = OFF, a Presence = ON telegram is received and the
room brightness is below the parameterised setpoint, then the lighting is
switched in brightness on-off control. In constant light regulation, in this case
this would be decided by the parameterisation. Either the lighting is switched
on (to the switch-on value parameterised for the actuator) and then dimmed
automatically, or a dimming value telegram is transmitted immediately. In any
case the control tries to regulate the brightness to the setpoint.
If, on the other hand, it is bright enough in the room when Presence = =ON is
received, then the lighting is only switched on automatically later by the
activated brightness control or constant light regulation if the room brightness
has dropped below the setpoint.
Function:
Enabling control
Object
h
1
Function
On / Off
Name
Automatic mode
Type
1-bit
DPT
1.001
Flag
C, W, -, R
Description
This object can, for example, be linked with a pushbutton that is used to switch
the brightness controller on or off via the automatic mode. In this manner it is
possible to enable or disable the brightness control or constant light
regulation.
The command Automatic mode = OFF is used when brightness control is
activated to interrupt the automatic control of the lighting via switching or
dimming value commands. In constant light regulation this freezes the current
brightness state of the lighting. The lighting can then by dimmed by the user of
the room to a desired value without the lighting state being overridden and
changed immediately by the constant light regulation.
If the device receives the command Automatic mode = ON, the light control is
enabled again.
Page 13 of 27
Software "Brightness controller A01001"
Object table
