JUKI MS-1261A-DWS, Инструкция по эксплуатации

Страница: 34 / 77

– 31 –
⑦ The end of the multi-layered section of material
When the measured value by the multi-layered section sensor reaches the "S011 Multi-layered section
changeover sensor ON" value or less, the sewing state shifts to the "state of the flat section of material".
After the sewing machine completes sewing of "S017 The number of stitches to be sewn on the multi-layered
section" in the "state of sewing the multi-layered section of material", the sewing state shifts to the state of
the "end of the multi-layered section of material". (In the case the number of stitches set for "S017 The num-
ber of stitches to be sewn on the multi-layered section" is "0 (zero)", the sewing states will shift to the state
of the "end of the multi-layered section of material" when the measured value by the multi-layered section
sensor reaches the "S021 Multi-layered section changeover sensor OFF value" or less.)
Set "S017 Number of stitches to be sewn on the multi-layered section" according to the length and shape of
the multi-layered section of material
* Sewing conditions may differ according to the type of material and the condition of the multi-lay-
ered section. If the stitch gathers at the multi-layered section of material, change the settings of
sewing data to be used in
⑤ and ⑥ .
State display on the operation panel:
The following data items are used.
S004 Limit of sewing speed
S005 Presser foot pressure
S007 Cloth puller pressure
S006 Cloth pulling amount
⑧ Flat section
State display on the operation panel:
The following data items are used.
S004 Limit of sewing speed
S005 Presser foot pressure
S007 Cloth puller pressure
S006 Cloth pulling amount
After the sewing machine completes sewing of "S068 The number of stitches at which the cloth puller runs
on the multi-layered section" from the start of running on the multi-layered section (
⑤ ), the sewing state
shifts to the state of the "cloth puller runs on the multi-layered section of material".