– 41 –
No.
Item name
Input range
S042 Number of stitches
at which the chain-off
thread cutter is actuated
after the detection of
absence of material
0 to 2000 stitches
This data item is used for setting the number of stitches
to be sewn before actuating the chain-off thread cutter
after the detection of the absence of material.
S043 Selection of chain-off
thread cutter operation
by a depress on the back
part of pedal
Operate / Not operate
This data item is used for selecting the operation of the
chain-off thread cutter when the back part of pedal is
depressed to the second level.
S051
Needle bar stop position
Stop at the
upper posi-
tion
Stop at
the lower
position
-
S052
*
1
Limit to the sewing speed
to be applied after the
detection of absence of
material
150 to 5500sti/min
This data item is used for setting the sewing speed to be
employed when the absence of material is detected.
S053 Needle-cooler ON delay
number of stitches
0 to 200 stitches
This data item is used for setting the number of stitches
to be sewn from the time at which the sewing machine is
started to the time at which the needle cooler is actuat-
ed.
S061 Part number
0 - 24 characters
S062 Process
0 - 24 characters
S063 Comment
0 - 50 characters
S068 Number of stitches at
which the cloth puller
starts running on the
multi-layered section
0 to 200
stitches
-
This data item is used for setting the number of stitch-
es to be sewn from the time at which the multi-layered
section of material is detected to the time at which the
multi-layered section is brought to the cloth puller.
S069 Number of stitches during
which the cloth puller
runs on the multi-layered
section
0 to 200
stitches
-
This data item is used for setting the number of stitches
to be sewn while the cloth puller runs on the multi-lay-
ered section of material.
S070 Cloth pulling amount
when the cloth puller
runs on the multi-layered
section
1.2 to
5.5mm
-
This data item is used for setting the cloth pulling amount
to be used while the cloth puller runs on the multi-lay-
ered section of material.
S071
*
3
Cloth puller pressure
when the cloth puller
runs on the multi-layered
section
–
90 to
120
-
This data item is used for setting the cloth puller pres-
sure to be applied while the cloth puller runs on the
multi-layered section of material.
S072 Cloth pulling amount
when detecting no mate-
rial
1.2 to 5.5mm
*1: The actual sewing speed is limited by "S003 Stitch length" and the set value of cloth pulling amount.
In the case the set value of stitch length is 3.1 mm or more: Maximum sewing speed 5000 sti/min
In the case the set value of cloth pulling amount is 4.6 mm or more: Maximum sewing speed 4000 sti/min
*2: If this value is set to a negative value (minus value), the presser foot will go up. If the presser foot height is set so
that it floats, the multi-layered section changeover function will be disabled.
*3: If this value is set to a negative value (minus value), the cloth puller will go up.
Содержание MS-1261A-DWS
Страница 1: ...MS 1261A DWS INSTRUCTION MANUAL...
