JUKI DDL-8000A, Руководство инженера

Страница: 81 / 173

– 68 –
Adjustment Procedure Results of Improper Adjustment
3) Adjustment of the bobbin winder unit
In regard to adjustments of the bobbin winder amount and winder
imbalance, refer to the relevant instruction manual.
In this manual, descriptions are provided in regard to problems of
winder shaft revolution errors.
1. Replacement of the bobbin friction wheel
1. Remove two bobbin winder unit setscrews ❶ .
2. Take out the bobbin winder unit
❷
.
3. Confirm if there is extreme wearing out in the rubber section of the
bobbin winder friction wheel
❸
.
If the amount of wearing out seems to be too much, replace the
worn-out section with a new one.
Bobbin winder friction wheel ❸
Part No. 40191114
2. Adjustment of the bobbin winder driver wheel position
1. Remove the window plate from the rear side of the arm.
2
. Loosen the bobbin winder driver wheel setscrews ❺ (2 pcs.) of
the bobbin winder driver wheel ❹ .
3. Mount the bobbin winder unit ❷ on the arm.
4. Turn ON the bobbin winder lever ❻ and let the head ❶ coincide
with the bobbin winder lever ❻ .
At that time, the head ❶ of the bobbin winder unit setscrew shall
be made to coincide with the bobbin winder lever ❻ .
5. Lightly make the bobbin winder driver wheel ❹ lightly contact with
the bobbin winder friction wheel ❸ and tighten two bobbin winder
driver wheel setscrews ❺ .
(Cautions) 1. When the bobbin winder lever ❻ is turned OFF,
turn the hand wheel by hand and confirm that the
bobbin winder shaft ❼ does not turn.
2. Never apply grease or such an oily component to
the rubber section of the bobbin winder friction
wheel
❸ . Otherwise, this can be a cause of fric-
tion.
○ If the hand wheel is turned in the
state of OFF, this can be a cause
of abnormal abrasion.