JUKI DDL-8000A, Руководство инженера

Страница: 142 / 173

– 129 –
④ Installing the condensation arm
❿
❽
Ａ
Ａ
Ａ
⓰
Solenoid plunger
Up
1) Apply JUKI Grease A to the sliding surfaces A of
condensation arm ❽ and hinge screw ❿ , and the
contact surfaces of the spring and condensation
arm
❽ .
2) Secure condensation arm ❽ to which the
condensation arm return spring is attached, with
hinge screw
❿ .
[ Tightening torque: 7.8 - 8.8 N·m (80 - 90 kgf·cm)]
3) Put one end of the condensation return spring on
condensation arm stopper ⓰ .
⑤ Installing the feed adjustment pin
1) Reversing the removal procedure, install the feed adjustment pin.
2) Carry out adjustment of the forward / reverse feed alignment, etc. where appropriate.
3) Apply JUKI Grease A to the sliding surfaces.
⑥
Setting up the condensation plunger
1) Apply JUKI Grease A to the sliding surfaces of
condensation arm ❽ and hinge screw ❿ , and the
contact surfaces of the spring and condensation
arm
❽ .
2) Place the solenoid plunger in the forked section
of condensation arm ❽ .
(Caution) Turn the notched side of the solenoid
plunger upward. If the solenoid plunger
is attached in the wrong orientation,
the condensation stitch device will not
move.