JUKI AW-3S, Инструкция по эксплуатации

Страница: 32 / 47

– 30 –
(4) In the case the device remains in the finished state of previous sewing
(In the case the previous sewing has been normally finished, and
one bobbin is placed in the hook and the other bobbin is placed in
the bobbin setting section.)
1) Turn the power to the device.
2) Press
N
to display the sewing screen. Once the sewing
screen is displayed, sewing can be started.
In other words, the operation required in the aforementioned state
is only to turn ON the power to the device. Note that the number
of stitches is set at the value that is effective at the end of previous
sewing. So, sewing can be started continuously from the previous
sewing.
<Data input screen>
(3) In other case
(In the case one or two bobbins are loaded in the device (including
the hook) other than the case (2).)
1) Turn the power to the device.
2) If a bobbin is loaded in the bobbin setting section, take it out.
3) If any other bobbin still remains in the device (or in the hook),
press Q to make the bobbin setting section to feed the
bobbin to a position at which the bobbin can be taken out.
Then, carry out the operation procedure (1) or (2).
<AW operation screen>
N
Q
Be sure to carry the bobbin to the bobbin setting sec -
tion with Q before removing the bobbin which is
placed in the hook where necessary. If you attempt to
remove the bobbin directly from the hook, the sewing
machine may operate while no bobbin is placed in the
hook.