– 9 –
(2) How to load a bobbin in the device
Load the bobbin case fitted with a bobbin, as
described in (1), in bobbin setting section
❺
of the
device.
Load the bobbin case fitted with a bobbin while
putting your hand from under the right side of the
cover located this side of the device.
Set the bobbin case in such a way that its opening
section
❸
aligns with lock member
❹
.
Place the bobbin case in the device with the claw
of bobbin case raised. Push the bobbin case in
the device fully until it will go no further.
If the bobbin case is not correctly placed in the bobbin setting section
❺
of the device, an
error such that the gripper fails to catch the bobbin case can occur.
If the bobbin case is not correctly placed in the device, the bobbin case can drop from the
device without raising its claw.
Keeping the bobbin case lever held opened widely with your fingers, insert the bobbin
case into the hook as far as it will go. If the lever is not opened widely enough, the bobbin
may interfere with the claw part of the hook to prevent the bobbin case from being inserted
to its locking position. If the bobbin case is not correctly inserted in the hook, it may drop
during sewing to cause needle breakage or bobbin case breakage.
❹
❺
❸
In order to set the bobbin case in the hook section without fail, do not carry out attach
-
ment, removal or setting of the bobbin case directly by hand but place the bobbin case
firstly on the standby position.
After you have set the bobbin case in the device, make sure that the bobbin case has not
dropped from the device.
Interference
The state that the bobbin case is correctly
placed in the hook
Lever is not
opened sufficiently
Содержание AW-3S
Страница 1: ...1 INSTRUCTION MANUAL AW 3S...
Страница 4: ...2 1 2 Configuration The illustration shows the AMS 221EN...
