JUKI AW-3S, Инструкция по эксплуатации

Страница: 13 / 47

– 11 –
<Bobbin check screen>
C
D
6) Place the first bobbin in bobbin setting section ❷ by hand.
・ In the case of an empty bobbin, press C .
・ In the case of a bobbin that has already been wound with
thread, press A firstly, then press D .
The bobbin is carried to the hook.
7) Subsequently, place the second bobbin in bobbin setting sec-
tion
❷
.
・ As with step 6), press C in the case of an empty
bobbin.
・
Press
D
in the case of a bobbin that has already
been wound with thread.
8) Press
E
to return the screen to the data input screen.
If one of the bobbins placed in the bobbin setting section is an
empty bobbin, the device will wind thread on the bobbin. After the
device completes winding of the bobbin, it will enter the standby
state in preparation for bobbin replacement.
3-4. Length of remaining thread to be removed
During the remaining-thread removal operation,
bobbin clutch holes
❶ turn as the bobbin rotates.
The device recognizes that the remaining thread
is being removed by detecting turning of the bob-
bin clutch holes
❶ .
The maximum length of remaining
thread that can be removed in 8 m.
Be aware that a remaining-thread re
-
moval error may occur if the bobbin is
wound with thread to such an extent
that the bobbin clutch holes
❶ are
hidden by the thread. If the length of
thread remaining on the bobbin ex
-
ceeds 8 m, it is necessary to remove
the thread from the bobbin by hand.
❶
E