JUKI AMB-289, Руководство инженера

Страница: 112 / 177

– 108 –
Needle entry interval of bottom feed (longitudinal)
This item sets the needle entry interval
of bottom feed.
Needle entry interval of bottom feed (lateral)
This item sets the needle entry interval
of bottom feed.
Stitching count for button sewing
This item sets the number of crossover
stitches for button sewing.
Number of stitches at the start of button sewing (1 to 3 stitches)
This item sets the number of stitches at the
start of button sewing.
Compensation of lower left position of upper button
This item is set when cloth is pulled and the
amount of blindstitch on the left side is
different from that on the right side.
Compensation of 3rd stitch at the start of sewing
This item compensates the position of 3rd
stitch at the start of sewing to prevent thread
from slipping off at the start of button sewing
Blindstitch width
This item has to be set within the range
where needle and tongue do not come in
contact with each other.
Blindstitch amount
This item sets the blindstitch amount to cloth.
Buttonhole height of shank/marble button sewing
(Height from the feed plate)
This item is set to prevent the contact of
needle and buttonhole.
Thinning level of the stay button
This item decreases the number of cross-over stitches of
the lower side button at the time of stay button sewing.
: Without thinning : Thinning level 1
: Thinning level 2 : Thinning level 3
Lateral compensation of needle entry of lower
button at the time of sewing counter button
(front : 4 holes, rear : 2 holes)
Perform compensation to such an extent
that needle does not come in contact with
buttonhole within the range of lower buttonhole.
Number of stitches of tie stitch at the end of
sewing flat button directly to cloth.
This item sets the number of stitches of tie
stitch at the end of sewing flat button directly
to cloth.
Number of stitches of tie stitch at the end of
counter sewing
This item sets the number of stitches of tie
stitch at the end of counter sewing.
No. Item Settomg range Ddit unit Initia display Remarks
0.10 to 6.00 0.05mm 3.20
0.10 to 6.00 0.05mm 3.20
2 to 32 2 stitchs 6
1 to3 1 stitch 1
–1.00 to 1.00 0.05mm 0
0 to 0.5 0.05mm 0
0.0 to K05 0.2mm 0.6 *1
–1.00 to 5.00 0.05mm 0.40
0.0 to 10.0 0.1mm 3.0
– – – – – – Without
thinning
0 to 0.30 0.05mm 0.3
2 to 3 1 stitch 2
1 to 3 1 stitch 2
* 1 The maximum value of the range of data editing depends on the setting of K05.