Judo 8210411, Инструкция по установке и эксплуатации

Страница: 19 / 48

JUDO BIOSTAT-COMBIMAT 19
Operation
5.12 Fault
The opening of the units, and the
exchange from parts that are water pres-
sure-charged must be carried out by
qualified personnel only!
If a fault occurs at the unit it will be indicated
by the LED 4 flashing red.
Deleting the error message:
Disconnect the power supply from
the socket. Plug it back in after
approx. 5 seconds!
Help with faults:
Fault Cause Remedy
Permanent red
light from LED 4
and permanent
acoustic signal. DIP switch
incorrectly set. – Reset DIP switch (see chapter “Setting the
flushing interval”).
LED 4 flashes red. Momentary
power failure. – Delete the failure message.
The appliance reverts automatically to normal
operation.
Cable connec-
tions have be
come loose. – Disconnect the power supply from the socket!
– Remove the covers (see chapter “Mounting the
cover caps”).
– Check the cable connections, reconnecting each
plug-and-socket connection which is loose.
– Remount the covers.
– Plug the power supply back into the socket.
Repeated fault
message after
having replugged
the power supply
in the socket. – Inform fitter or nearest available customer
service point without any delay.
Quote the appliance number (see appliance
number in front of the chapter entitled “About
these operating instructions”).
– Disconnect the power supply from the socket!
The water treatment device must remain switched
off until the arrival of the customer service.
– Set the bypass valve to “bypass”.
If there is no bypass valve mounted, ensure that
there is not any water escaping from the waste
water connection.
– Remove the ball-valve actuator with a sudden
pull. Close the ball-valve with the hand lever
included.
LED 3 flashes red. The battery is
empty. – Replace by a new battery (type alkaline).
Return run-down batteries to the collection
points.