JRC JHS-183, Инструкция по эксплуатации

Страница: 80 / 128

5-54
6. AREA (NE)
Select
6. AREA and set “NE” by inputting latitude and longitude.
・ If set by north latitude, select “N” with ▲ key or ▼ key. If set by south latitude, select “S”, and then
press ENT key and set.
・
The cursor moves to the latitude input line, set the figure with ▲ key or ▼ key and press ENT key
to determine. (refer to “5.2.5 numerical input method”)
・
After determination of the latitude, the cursor move to longitude input line.
・
If set by east longitude, select “E”, If set by west longitude, select “W” and then input the longitude.
The procedure is same as latitude.
These setting ranges are shown as follows, latitude from 0°00.00’ to 89°59.99’ and longitude
0°00.00’ to 179°59.99’.
・ Press ENT key and determine the input.
・
Press CLR key, the cursor return to previous digit.
7. AREA (SW)
Select
7. AREA and set “NE” by inputting latitude and longitude.
・
The setting procedure is same as “6. AREA (NE)”.
After setting of item from 1 to 7, carry out the “CHECK” of the setting (as shown nest page)
8. The source of regional channel setting
（
SOURCE/MMSI/UTC
）
This item “8.SOURCE/MMSI/UTC” displays the channel setting information.
This is display only, settings and selection are not available.
These contents are shown below.
SOURCE… The means of setting
The regional setting is managed by 5 types.
1. ADDRESSED MSG.22 : Channel management to this ship
2. BROADCAST MSG.22 : Channel managements to all ships
3. CH ASSIGNMENT : Managed by other equipments connected with NQE-5183
4.DSC 70CH TELCOM : Channel management by DSC telecommand
5.MANUAL INPUT : Channel management by oneself
MMSI…… MMSI number of the station which operates the setting indication.
UTC………UTC time AIS received the indication
If CLR key is selected, the display is switched to SET UP menu.