Joyello JL-1048 SECURFIX BEEP, Руководство пользователя

Страница: 29 / 68

29
GB
INSTALLATION FOR GROUP 1 (9-18 kg). Forward-facing
17. Maintenance and cleaning
17.1 Daily maintenance
1.In daily use,check periodically the child seat.The child seat should be replaced
after an accident.
2.Please keep this child seat in dry and ventilated place to avoid damp moldy.
3.If the child seat becomes dusty,clean the seat belt and the plastic pieces by
swiping them with a damp sponge and let it dry under ambiance.
4.If food or drink drop accidently on the buckle,disassemble the seat belt from
the child seat and rinse it gently by warm water.Leave it dry under ambiance.
5.For cleaning the entire child seat fabric cover,please refer to the 17.2 washing
instruction.
17.2 Washing instruction
Never use any solvant,chemical detergent or lubricant on any part of your
child seat.
Hand wash,
water
temperature
below 30
℃
Do not bleach
Dryclean,any
solvent except
trichloroethylene
Do not tumble dry Do not iron
17.3 Remove and assemble the fabric cover
1. Firstly,remove the crotch pad and buckle of the child seat(see page 9),and
then remove the shoulder straps and comfortable cushion.
2.Remove the fabric cover of the child seat.To install the fabric cover,please
operate follow the above instructions in reverse order.
16. Installing the safety group I
13 14
OK!
D4
D 2
D7 D 6
D5
P
USH
It is suitable for the weight 9-18 kg,given to children about 9months-4 years old.
Pull outward ISOFIX base to ensure that both sides have been locked.
STEP 2:
STEP 3:
Push in the direction of car back seat,make sure that the backrest of the
baby seat is firmly pressed against the backrest of car seat (D5).
STEP 4: There are 3 recline position available. Adjust the seat to suitable position(D6).
STEP 1: Flat on the ISOFIX base on the car seat,the ISOFIX base connected with the
connection device on the car(D1).
Combine the car seat with isofix base(D2,D3,D4).
NOTE:
STEP 5:
By adjusting the length of the leg to make it
touch the ground of car.
Leg not hanging in the air or other items can be
used to support.At thesame time to ensure that the
leg is no higher than the safety seat.Check whether
leg shows green(D7).
NOTE:
D3
D1
CAUTION! Children weighing less than 9 kg must not be placed in a child seat mounted
in a forward-facing position.
Place the seat base on the vehicle’s seat and extend the ISOFIX connector arms (fig.D1). Ensure that
the base is correctly connected on both sides.
Insert the child seat into the base (fig.D2/D3/D4).
Press the base against the vehicle’s seat to bring the child seat as close as possible to the backrest
of the vehicle’s seat (fig.D5).
Recline the child seat into the desired position (3 available positions - Fig. D6).
Adjust the height of the support leg so it rests solidly on the floor of the vehicle. To be sure that
the support leg is correctly placed on the floor of the vehicle, ensure that the green indicator is
showing (fig.D7).
CLEANING AND MAINTENANCE
Cleaning and maintenance must only be carried out by adults.
The child seat’s moving parts must not be lubricated in any way