the velocity is turned up more, negative values will reverse its functioning. The Velocity
Amount has ist limits within the value of the Routing-Amount (because it is added or
subtracted from this).
4.
(Soft-Controller) < Curve >
(Velocity-curve)
This parameter sets the attack curve. The relation between the amount increase and the
velocity can be set in four steps (= four curve shapes). This way, you can fine-tune the way
velocity affects a parameter.
< lin >
linear – constant increase
< log >
logarithmic – the parameter
increases a lot, even with small
controller changes.
< exp1 >
exponential 1 – the
parameter changes increase as the
controller sends out increasing
values.
< exp2 >
exponential 2 – as exp1,
but less extreme
Routing Elements-Menu (Soft-Button) < Rout >
Here you get to the submenu to set the modulation amount of the 4 routing elements. Please
read chapter
3-10-2-3
for more information on this.
Envelope 3-Menu (Soft-Button) < ENV3 >
Here you alter the settings of the software generated envelope 3 (this is not yet
implemented).
Out
(Output Assignement)
(Soft-Button) < Out >
The LC-Display shows
Here you can assign the outputs, control the levels and the panning LFO. The four soft
controllers/buttons have the following functions:
1.
(Soft-Controller) < OutNo >
(output number)
This selects the individual outputs
< 001 >
to
< 008 >.
2.
(Soft-Controller) < Level >
(level)
This sets the level of the output signal
< 000 >
to
< 127 >.
Menu-Driven Features
3-11
076
Single Mode
127
0
Parameter
Value
127
exp 1
exp 2
lin
log
Velocity
thebook-all 07.11.2002 18:29 Uhr Seite 76 (Schwarz Bogen)
