joke 4065735316068, Руководство по эксплуатации

Страница: 13 / 30

13 13
Fitting/changing the electrode
The choice of electrode depends on the size and shape of the surface to be coated. Workpieces
with simple shapes can be coated with a 1.6 or 2.1 mm square electrode. Dies with complicated
internal shapes or small holes are coated with the appropriate round, 3-sided or 4-sided elec-
trode. For small holes of less than Ø 1.2 mm, the round 1 mm electrode is ground at least 0.2 mm
thinner than the hole to be coated on a diamond or silicon grinding wheel.
Caution!
To avoid injuries caused by the hot surface of the tool, only connect or change tools when the
control unit is switched off .
Caution!
To avoid injury from tools coming loose, always tighten the tools carefully and regularly check the
fi t of the tool.
Attention!
To avoid damage to the components,
• thoroughly clean all parts before installing them and
• use only the screwdriver supplied.
1.
2.
3.
4.
6.
5.
10
Fig. 12