joke 4065735316068, Руководство по эксплуатации

Страница: 5 / 30

55
Notes about these instructions
These operating instructions enable the operator to correctly use, take care of and maintain the
ENESKArecoat 85 carbide coating system. These operating instructions are part of the system
and must always be kept at hand at the place of use. If the system is passed on to a third party
then this operating manual must be passed on too.
To avoid injury and damage to property, read these instructions before performing any work
with the system!
Instructions which must be strictly observed to prevent hazards or damage are marked as
follows:
Caution!
Warns of hazards that can lead to injuries.
Attention!
Warns of hazards that can lead to damage to objects.
For technical problems or other questions please contact our service department.
Product overview
USB
START
FOOT
MEM
PAR 1
PAR 2
ESC
3
4
5
6 7
1
2
Fig. 1
1 Control unit with mains cable 5 Electrodes
2 Vib85 application handpiece with hand-
piece cable incl. welding and control
cable plug 6 Screwdriver
3 Spare screw 7 Ground cable with welding cable plug and
contact magnet
4 Clamping element
The ENESKArecoat 85 carbide coating system operates according to the principle of electro-dis-
charge machining. A carbide electrode is attached to the positive pole of a DC circuit. It is made
to vibrate in the Vib85 application handpiece. The workpiece is connected to the negative pole.
During the brief contact pulse between the workpiece and the electrode, the electrode is briefl y
overheated by the fl owing current to such an extent that, during the discharge, carbide particles
from the electrode are entrained and fuse to the workpiece surface.
1
2