Johnson Horizon Fitness 7.0AT-04, Руководство по обслуживанию

Страница: 9 / 50

9
CHAPTER 2: PREVENTATIVE MAINTENANCE
Your treadmill came with a bottle of lubricant which can be used for two applications.

Turn off the treadmill with the on/off
switch, then unplug the power cord at
the wall outlet.

Loosen both the rear roller bolts. (For
best results, place two removable marks
on both sides of the frame and note
roller position). Once the belt is
loosened, take the bottle of lubricant
and apply it to the entire top surface of
the running deck.

Tighten both rear roller bolts (matching
up the marks for proper position) to
original position. After you have applied lubricant, plug in the power cord, insert the safety key,
start the treadmill and walk on the belt or two minutes to spread the lubricant.

Lubricate the air shocks with Teflon based spray.

When lubrication is complete, hold the “speed up” (+) and “stop” keys for seconds. This will
remove the message.
2.2 TENSIONING & CENTERING THE RUNNING BELT
If you can feel a slipping sensation when running on the treadmill, the running belt must be tightened. In
most cases, the belt has stretched from use, causing the belt to slip. This is a normal and common
adjustment. To eliminate this slipping, turn the treadmill off and tension both the rear roller bolts using
the supplied Allen wrench, turning them ¼ turn to the right as shown. Turn the treadmill on and check
for slipping. Repeat if necessary, but never turn the roller bolts more than ¼ turn at a time. Belt is
properly tightened when the slipping sensation is gone.
The running belt has been properly adjusted at the factory before it was shipped. At times the belt can
move off-center during shipment. Before operating the treadmill, make sure the belt is centered and
remains centered to maintain smooth operation.