Johnson Controls JWS-3, Инструкция по установке и эксплуатации

Страница: 13 / 54

13 JWS-3 Installation and Operation Manual - P/N: 53550:Rev: A1 1/12/10
Section 2 JWS-3 Embedded Installation
2.1 Required Equipment
The JWS-3 requires the following:
JWS-3 Assembly
The following are shipped with the JWS-3:
• JWS-3 printed circuit board
• PNET-1 surge suppressor (P/N PNET-1)
• RJ45 to RJ45 standard Ethernet network cable (P/N 75585—used to connect the JWS-3 board
to PNET-1 surge suppressor
• NUP to NUP Cable—(P/N 75556) used to connect the JWS-3 board to an HS-NCM-W/SF/
MF, an NCM-W/F, or an FACP
• Wire Leads to NUP Network Communications Module power cable (P/N 75583)
Network Components
• RJ45 to RJ45 standard Ethernet network cable—customer’s internet or intranet connection to
the JWS-3 board
• NFN network—version 5.0 or above (sold separately)
• High-Speed Network Communication Module: HS-NCM-W/SF/MF or Network
Communication Module: NCM-W/F—used to facilitate network communication between the
JWS-3 and NFN network (sold separately)
Cabinet and Hardware (sold separately)
• CAB-3/CAB-4 series cabinet
• CHS-4L chassis
Customer Supplied Equipment
• A computer to monitor and configure the JWS-3
2.2 JWS-3 Installation Overview
This is the recommend installation order:
• “Installing a CAB3/CAB4 Cabinet” on page 15
• “Installing the JWS-3 Printed Circuit Board” on page 17 .
• “Installing the Network Communication Module” on page 19 (if applicable).
NOTE: No HS-NCM-W/SF/MF or NCM-W/F is required when the JWS-3 connects directly to a
supported Johnson Controls panel when it is a standalone panel. Refer to Section A.1, “Direct
Connect Node Type Compatibility” on page 47 for a list of supported panels.