49
JWS-3 Installation and Operation Manual - P/N: 53550:Rev: A1 1/12/10
Appendix B: JWS-3 Local Configuration
B.1 Direct Connection to the Gateway PC Board
Step 1. Connect the cross over cable between the Configuration PC network card’s RJ45
connector and the JWS-3 PC board’s RJ45 connector (refer to
).
Figure B.1 Configuration PC Direct Connection
Step 2. You have completed the connections, proceed to
“IP Network Configuration” on page 25
.
Cross Over Cable Specifications
This cross over cable will be directly connected between the Configuration PC network card’s RJ45
connector and the JWS-3 PC board’s RJ45 connector.
NOTE:
This procedure is only necessary if you are configuring an JWS-3 using a Configuration
PC that is not already on the same IP network as the JWS-3. Refer to
NOTE:
A direct connection requires that a cross over Ethernet cable to be made or purchased
by the customer.
To Internet or Intranet
Customer Supplied Cable
Ethernet
Connector (J8)
PNET-1
Содержание JWS-3
Страница 1: ...JWS 3 Installation and Operation Manual Document 53550 1 12 10 Rev A1 P N 53550 A1 ECN 10 018...
Страница 12: ...JWS 3 Features System Architecture 12 JWS 3 Installation and Operation Manual P N 53550 Rev A1 1 12 10...
Страница 46: ...JWS 3 Operation Administration Tab 46 JWS 3 Installation and Operation Manual P N 53550 Rev A1 1 12 10...