Johnson Controls JWS-3, Инструкция по установке и эксплуатации

Страница: 39 / 54

Administration Tab JWS-3 Operation
39 JWS-3 Installation and Operation Manual - P/N: 53550:Rev: A1 1/12/10
Internet Address Settings
IP Address
This is the actual IP address where the JWS-3 will be located. Type the address by
double clicking on the data field to the right of the description field. The user will type this address
into a browser in order to establish a connection with the JWS-3. If the JWS-3 is to be used on the
internet, you may need to independently set up a router and/or fire-wall so the internet-based
applications can locate and access the JWS-3. Contact your MIS department for details. To actually
connect to the JWS-3 requires use of TCP/IP port 8888; for example, if the JWS-3 is located at
10.4.2.1, one would type the following into the browser window to connect to the JWS-3.
Subnet Mask
This is the IP subnet mask that the JWS-3 should use to determine whether a
connection came from a local network, or should be routed on to another network (see previous
setting). All of the IP settings for the JWS-3 must be on the same subnet for communications to be
established between the JWS-3 and a browser.
IP Gateway
This sets the IP of a router that the JWS-3 can use to locate the browser with which it
is communicating. This simply sets a path for the JWS-3 to use to communicate back with the
connecting browser.
MAC Address
This is the hardware MAC address of the device hosting JWS-3.
4.7.3 Time Zone Settings
It is absolutely necessary that you configure the Time Zone settings to ensure JWS-3 accurately
handles time and date information. Enter the time zone where JWS-3 is running. Also select
whether or not Daylight Savings Time (DST) is observed in the area, and the relevant date start and
end times if so.
Figure 4.15 Time Zone Settings