Johnson & Starley WARMCAIR C26D, Инструкции по установке, пусконаладке и обслуживанию

Страница: 9 / 44

9 Sales/Spares & Replacement Help Line 01604 762881
EXTENDED HORIZONTAL
REAR FLUE
VERTICAL FLUE
FIGURE 2.
EXTENDED HORIZONTAL REAR FLUE
FIGURE 3. VERTICAL FLUE
FIGURE 4. HORIZONTAL TERMINAL DIMENSIONS & POSITION
9. FLUE INSTRUCTIONS
9.1 The WarmCair C26D Condensing Air Heater is certified as a warm air heater with corresponding flue systems
according to EU Directive 2009 / 142 / EC on gas-fired devices. These installation instructions are covered by
this certification and are referred to in the design approval test certificate.
9.2 The installation of the warm air heater and flue system must be in accordance with the Gas Safety (Installation
and Use) Regulations 1998 and the Building Regulations. If no specific instructions are given, reference should
be made to the relevant codes of practice.
THESE RELEVANT STANDARDS SHOULD BE FOLLOWED
BS 5440:1 Flues and ventilation for gas appliances of rated heating input not exceeding 70 kW (net) : Flues
BS 5440:2 Flues and ventilation for gas appliances of rated heating input not exceeding 70 kW (net) : Air
Supply
Ensure all legislation, regulations and directives mentioned are observed.
9.3 The air / flue duct operates at very low temperatures, therefore no clearance is
necessary between the air duct and the adjacent services.
9.4 Ensure while installation work is being carried out that no debris such as swarf,
filings or fragments of mortar are allowed to remain in the air / flue duct.
9.5 FLUE CONFIGURATIONS
NOTE:
Vertical Appliance adaptor is fitted as part of the air heater.
CORRECT
POSITION OF
HORIZONTAL
TERMINAL END
100 mm
19 mm
EXTENDED HORIZONTAL
REAR FLUE
Can be fitted to the left or the right
Vertical Appliance Adaptor
Horizontal Terminal
90˚ Elbow
Required Extension Length
Vertical Appliance Adaptor
Required Extension Lengths
Vertical Terminal