Johnson & Johnson ASP STERRAD 100S, Руководство по установке

Страница: 42 / 44

Chapter 3. Installation
STERRAD
®
100S Installation Guide
42
4. Press OPEN DOOR to change the MM, DD, and YY each in turn
until the desired setting is displayed. Press CLOSE DOOR each
time to move the cursor to the next field. After the YY is updated,
the following message is displayed on the LCD:
TIME=HH:MM:SS AM
OPEN(change) - CLOSE (accept)
HH is the hour of the day, e.g., 09; MM is the minutes, e.g., 12; SS is the
seconds, e.g., 43; AM represents after midnight and PM represents after
noontime.
5. Press OPEN DOOR to change the HH, MM, and SS each in turn
until the desired setting is displayed. Press CLOSE DOOR each
time to move the cursor to the next field. After the AM/PM is
updated, the current date is displayed.
6. After the desired date and time settings have been obtained,
simultaneously press START and CANCEL to exit the month/time
program and continue to the PM Log Rest.
PM Log Reset
1. Press OPEN DOOR and START to enter the edit mode. The system
displays the total machine cycles. Press CANCEL to display the PM
warning. Press CANCEL again to display PM 1500 L1. The display
looks like the following example:
P.M. Y: NEXT PM 1500 L1
OPEN (reset) -
CANCEL
(next)
Note: The cursor flashes on the N/Y field. The NEXT
PM field displays the total remaining cycles
before the system stops running cycles.
2. Press OPEN DOOR to change the N default to Y (indicating
maintenance has been completed). Verify that the NEXT PM field
resets to the total allowable cycles (1500) between maintenance
intervals.
3. Press CANCEL (display moves to date), then press START and
CANCEL at the same time. The system display returns to the ready
state and prints the Maintenance Log.