PAGE
79
of
131
CX0098 Rev 07.5
6.
Mount the yoke to the opposite side of the base using the supplied 3 mm
hex driver
(Fig. 183)
.
TIP:
Keep the yoke level with the base as to ensure no conflicts with the
plunger/set screw attached to the yoke.
7.
Locate the recessed M3 screw
(stop post)
on the bottom of the probe
holder. Unscrew the stop post using a 1.5 mm hex wrench until it has
cleared all obstructions. Do not remove stop post
(Fig. 184)
.
8.
Raise the stop post on the opposite side until the side of the post clearly
contacts the 90° stop point on the probe holder’s base
(Fig. 185)
.
Fig. 183
-
Screw yoke to opposite side
Fig. 184
-
Lower 90° stop post
Fig. 185
-
Raise opposite 90° stop post
Fig. 186
-
Reversed probe holder
