Jinko JK2830, Руководство по эксплуатации

Страница: 11 / 71

JK2830 Operation Manual Chapter 2 Introduction
5
Press this key, the buzzer will beep, which means the function of current
panel is locked. Press it again, it will be off, which means discharging the lock
status. If the password function is ON, it means correct password is
necessary when discharging the key-lock, or the key cannot be unlocked.
9) [CLEAR]
Execute the calibration operation. Press this key to execute OPEN/SHORT
calibration.
10) POWER
Power switch
11) USB HOST interface
Connect U flash disk so as to save or use a specified file.
12) [TRIG]
When the trigger mode is set to MAN mode, press this key to trigger the
instrument.
13) Test terminals (UNKNOWN)
4-teminal test pair are used to connect 4-terminal test fixture or cable to
measure DUT.
The 4 terminals are respectively as follows: Hcur, Hpot, Lpot and Lcur.
14) Soft keys
Five soft keys are used to select parameters. The corresponding function of
each soft key has been displayed on its left (the right part of LCD). The
function definition varies with different pages.