JK2830 Series Operation Manual Chapter 3 Introduction to [DISP]
17
3.2
<BIN DISP>
Press
[MEAS]
firstly and then the
BIN DISP
soft key to enter into <BIN DISP>
display page. On this page, bin NO. is displayed in upper-case character while the
test result, in lower-case character.
The following control parameters can be set on <
BIN DISP
>.
◼
Measurement display page(
MEAS DISP
)
◼
Bin display page(
BIN DISP
)
◼
List sweep display page(
LIST SWEEP
)
◼
File list display page(
FILE LIST
)
◼
Next page(
MORE 1/2
)
Press
MORE 1/2
soft key the following soft keys will be displayed:
◼
Count function ON/OFF (
COUNTE OFF ON
)
◼
Compare function ON/OFF (
COMP OFF ON
)
◼
Counter reset(
RESET COUNT
)
◼
start to save data(
START SAVE CSV
)
◼
Return(
MORE 2/2
)
The following test result/ condition can be displayed in this page but cannot be set
in this page. Users can set them on the
<LIMIT TABLE >
page.
◼
Nominal value (NOM)
◼
Bin limit value (HIGH/ LOW)
3.2.1
Comparator function
JK2830 has an inserted compare function which can divide DUT to up to 4 bins
(from BIN1 to BIN3 and BIN OUT). Users can set 3 pairs of primary parameter
limit and one pair of secondary bin limit. If the primary parameter of DUT is within
Содержание JK2830
Страница 1: ......
Страница 2: ...I O OP PE ER RA AT TI IO ON N M MA AN NU UA AL L JK2830 Precision LCR meter ...
