JK2830 Series Operation Manual Chapter 3 Introduction to [DISP]
18
the range of the bin limit but the secondary parameter is outside of the bin limit,
the DUT will be sorted into the auxiliary bin. When JK2830 has installed an
HANDLER interface, the compare result will be output into the automatic test
system and further realizing auto-sorting test. These limits can only be set on the
<
LIMIT TABLE
> page. Users can set the compare function to ON or OFF in the
TOOL
zone.
Operation steps for compare function and bin count function:
1)
On <BIN DISP> page, press
MORE 1/2
soft key, the following soft keys will
be displayed.
◼
COUNT OFF ON
◼
COMP OFF ON
◼
RESET COUNT
2)
Press the soft key
COUNT OFF ON
to set the bin counter as ON or OFF.
3)
Press the soft key
COMP OFF ON
to set the compare function as ON or OFF.
4)
Press the soft key
RESET COUNT
,
“
Info: Sure clear bin counter
?” will be
displayed in the help zone. Then the following soft keys will be displayed.
◼
YES
◼
NO
5)
Press the soft key
YES
to reset all bin counts to 0.
6)
Press the soft key
NO
to cancel the reset operation.
3.2.2
BIN
This zone shows the bin number of the limit list.
3.2.3
HIGH/LOW
This zone shows the high and the low limits of the limit list.
3.2.4
COUNT
This zone shows the count value of the current bin.
3.2.5
AUX
This zone shows the count value of the auxiliary bin.
3.2.6
OUT
This zone shows the count value of the out bin.
Содержание JK2830
Страница 1: ......
Страница 2: ...I O OP PE ER RA AT TI IO ON N M MA AN NU UA AL L JK2830 Precision LCR meter ...
