Jetter JVM-507B - HMI, Руководство пользователя

Страница: 46 / 152

46 Jetter AG
5 Mounting and installation of the JVM-507B
The configuration memory
The HMI retrieves the parameters for initializing the IP interface from the
configuration memory during the boot process. The user can access the data
stored in the configuration memory in the following ways:

The web interface lets you read out data and make changes to them.
 Registers let you read out data and make changes to them.
The HMI reads data located in the configuration memory only during the boot
process. If you make changes to the configuration memory, reboot the HMI for
these changes to take effect. Only this way these changes take effect.
If you change the IP address during runtime, this modification immediately
takes effect. However, changes made during runtime are not remanent.
Before the HMI uses data from the configuration memory, it checks them for
plausibility. If entries are invalid or absent, the HMI uses the following default
values:
Parameter Default value
IP address of the controller 192.168.10.15
Subnet mask 255.255.255.0
IP address of default gateway 0.0.0.0
 Configuration registers (see page 47)
Introduction
Enabling conditions
Default values
Related topics