Jeep AVENGER 2023, Руководство пользователя

Страница: 97 / 300

95
In certain driving conditions such as poor
road surface or strong winds etc., the
system may give alerts independent of
the driver's level of vigilance.
The driver drowsiness detection is
reinitialised when the ignition has been
switched off for a few minutes or the
speed remains below 65 km/h for a few
minutes.
System limitations
In the following situations, the system
may not operate properly or even not
operate at all:
poor visibility caused by inadequate
lighting of the roadway, falling snow,
heavy rain, dense fog etc.
dazzle caused by headlamps of
oncoming vehicles, low sun, reflections
on damp roads, leaving a tunnel,
alternating shade and light etc.
windscreen area in front of the camera
covered by dirt, snow, stickers etc.
no lane markings detected or multiple
lane markings due to roadworks
close vehicles ahead
winding roads or narrow roads
TYRE UNDERINFLATION
DETECTION SYSTEM
100) 101) 102) 103)
The Tyre Underinflation Detection
System continually checks the rotation
speed of all four wheels and warns on
low tyre pressure condition once vehicle
is driving. This is achieved by comparing
tyre rolling circumference with reference
values and further signals.
If a tyre loses pressure the control
indicator
illuminates and a warning
message is displayed in the instrument
panel display.
In this case reduce speed, avoid sharp
cornering and strong braking. Stop at
next safe opportunity and check tyre
pressure.
After adjusting tyre pressure initialise
system to extinguish the control indicator
and restart system.
If the failure continues to be displayed,
contact a Jeep Dealership. The system is
inoperable when the ABS or Electronic
Stability Control has a malfunction or
a temporary spare wheel is used. Once
the tyre has been refitted, check the tyre
pressure with cold tyres and initialise the
system.
System initialisation
After tyre pressure correction or wheel
change, the system must be initialised
to learn new circumference reference
values:
Always ensure that all four tyres have
correct tyre pressure.
Apply parking brake.
Initialise the system via the
Uconnect™ 10,25"/10,25" NAV fig. 133
(Settings>Vehicle>Safety).
133
JJ000711
Reset is confirmed by pop-up
indication.
After initialisation system automatically
calibrates to new tyre pressures during
driving. After longer drive the system will
adopt and monitor new pressures.
The Tyre Underinflation Detection
signals the driver a possible insufficient
pressure if this falls below the warning
limit for any reason.
Always check tyre pressure with cold
tyres.
System has to be reinitialised when:
Tyre pressure has been changed
Load condition has been changed
Wheels have been swapped or
exchanged
Tyre pressure is affected by
temperature decrease
When the space-saver wheel is fitted
In these cases the system can require a
Reset. If the signals persist, contact a
Jeep Dealership.