Jeep AVENGER 2023, Руководство пользователя

Страница: 17 / 300

15
ignition switching on and starting the
engine
The electronic key simply needs to be on
the driver's person.
For reasons of security, the electronic
key may be equipped with a motion
sensor. If so, starting of the vehicle is
not possible when the electronic key
has not been moved for a certain time.
When trying to start the vehicle, a
corresponding message appears in
the instrument panel display. Move the
electronic key and try to start the vehicle
again.
Additionally, the electronic key includes
the functionality of the radio remote
control
Handle with care, protect from moisture
and high temperatures and avoid
unnecessary operation.
Fault
If the central locking cannot be operated
or the engine cannot be started, the
cause may be one of the following:
Fault in electronic key.
Electronic key is out of reception
range.
The battery voltage is too low.
Overload of the central locking system
by operating at frequent intervals, the
power supply is interrupted for a short
time.
Interference from higher-power radio
waves from other sources.
To rectify the cause of the fault, change
the position of the electronic key.
REPLACING BATTERY
IN RADIO REMOTE
CONTROL/ELECTRONIC KEY
13) 14) 15) 3)
Replace the battery as soon as the
system no longer operates properly or the
range is reduced.
In the event of a discharged battery,
illuminates and a warning message
is displayed in the instrument panel
display.
5
JJ000005_2
Batteries do not belong in household
waste. They must be disposed of at an
appropriate recycling collection point.
6
JJ000637
7
JJ000638
1. Remove the back cover by inserting a
small screwdriver in the slot and lift the
cover ( fig. 6 for radio remote control,
fig. 7 for electronic key).
2. Extract the flat battery from its
location.
3. Replace battery with a battery of the
same type. Insert the battery by pushing
it against the contact located in the
corner and then pressing it down. Pay
attention to the respect the polarity.
4. Clip the back cover in place.
5. Reinitialise the remote control.