Jeep AVENGER 2023, Руководство пользователя

Страница: 138 / 300

STARTING AND DRIVING
136
172)
Mud mode
This mode, when moving off, allows
considerable spin on the wheel with the
least grip to optimise clearing of the mud
and to regain grip. At the same time, the
wheel with the most grip is controlled
in such a way as to transmit as much
traction torque as possible.
When moving, the system optimises
wheel spin to respond to the driver's
requirements as fully as possible (mode
active up to 50 km/h (31 mph)).
Snow mode
This mode constantly adapts the level
of wheel spin to offer maximum traction
according to the snow conditions (a lot
of wheel spin in thick snow; very little on
ice). The wheel spin is also adapted to
the conditions encountered when driving
uphill by optimising the acceleration of
the vehicle (mode active up to 80 km/h
(50 mph)).
Recommendations
The vehicle is designed principally
to drive on tarmac roads, but it may
occasionally drive on other less passable
terrain. However, it does not permit
off-road driving:
Driving on terrain that can damage the
underbody or tear off elements (e.g. fuel
pipe, fuel cooler) by obstacles or stones
in particular
Driving on terrain with steep gradients
and poor grip
Crossing a waterway
WARNING
170) For optimum grip on snow, it is
recommended that you fit the vehicle
with winter tyres. For optimum system
performance, contact a Jeep Dealership to
choose the most suitable tyres.
171) Your driving style must always be
suited to the road conditions, visibility
and traffic. The driver is, in any case,
responsible for safe driving.
172) Do not use the other modes on sand
as the vehicle may become stuck.
STOP-START SYSTEM
(where provided)
The Stop-Start system helps to save fuel
and to reduce the exhaust emissions.
When conditions allow, it switches off
the engine as soon as the vehicle is at
a low speed or at a standstill, e.g. at a
traffic light or in a traffic jam.
Activation/deactivation
The Stop-Start system is available as
soon as the engine is started, the vehicle
starts-off and the conditions as stated
below in this section are fulfilled.
The deactivation and reactivation of the
Stop-Start system can be done through
the Uconnect™ 10.25"/10.25" NAV
settings.
AUTOSTOP
Activate an Autostop as follows:
Set the selector lever to neutral.
Release the clutch pedal.
The engine will be switched off while the
ignition stays on.
Indication
177
JJ000184
An Autostop is indicated by control
indicator .
During an Autostop, the heating and
brake performance will be maintained.
Conditions for an Autostop
The Stop-Start system checks if each of
the following conditions is fulfilled.
The Stop-Start system is not manually
deactivated.
The driver's door is closed or the
driver's seat belt is fastened.
The conventional battery is sufficiently
charged and in good condition.
The engine is warmed up.
The engine coolant temperature is not
too high.
The engine exhaust temperature is
not too high, e.g. after driving with high
engine load.