Jeep AVENGER 2023, Руководство пользователя

Страница: 131 / 300

129
On vehicles with Electric Drive Unit,
set the PRND command to position P,
operate the brake pedal and press the
STOP START ENGINE button.
This option is intended for emergencies
only. Replace the electronic key battery
as soon as possible.
For unlocking or locking the doors, see
"Doors" chapter in "Knowing your car"
section.
ELECTRIC VERSIONS
153)
The PRND command must be in position
P or N. Proceed as follows:
fully depress the brake pedal without
touching the accelerator
press the STOP START ENGINE
button to take the ignition switch to the
position 3. Hold it fully depressed for a
couple of seconds.
At the end of the procedure, an acoustic
warning will be heard and the message
"READY" will appear on the instrument
panel display to indicate that the electric
traction system of the car has started.
When the "READY" message appears, the
car is ready to go.
EMERGENCY SHUT OFF DURING
DRIVING
If the engine needs to be switched off
during driving in case of emergency,
press the STOP START ENGINE button
for 5 seconds.
157)
COLD START
RECOMMENDATIONS
Starting the engine without additional
heaters is possible down to -30
°
C for
petrol engines. Required is an engine
oil with the correct viscosity, the
correct fuel, performed services and a
sufficiently charged conventional vehicle
battery. It is necessary to do as follows:
run the engine (idle speed) at least 1
min before take-off vehicle
in very cold conditions, the enjoyability
of use will be reached after a few
kilometres
TURBO ENGINE WARM-UP
Upon start-up, engine available torque
may be limited for a short time,
especially when the engine temperature
is cold. The limitation is to allow the
lubrication system to fully protect the
engine.
OVERRUN CUT-OFF
The fuel supply is automatically cut off
during overrun, i.e. when the vehicle
is driven with a gear engaged but
accelerator pedal is released.
Depending on driving conditions, the
overrun cut-off may be deactivated.
WARNING
152)
It is dangerous to run the engine in
enclosed areas. The engine consumes
oxygen and engine exhaust contains
carbon dioxide, carbon monoxide and
other toxic gasses.
153) The brake servo is not active until
the engine is started, so you would need
to apply much more force than usual to
the brake pedal.
154) Do not start the engine by pushing,
towing or driving downhill. These
manoeuvres may damage the catalytic
converter.
155) Do not leave the vehicle in a
poorly ventilated area with electrical
operating mode on and heat engine
switched off, as the heat engine may start
automatically if the residual charge level
of the high-voltage battery is insufficient.
The exhaust gases generated can cause
serious damage to people and animals.
156) When leaving the vehicle, you must
set the PRND command to P. If you
unintentionally press the accelerator
pedal or when the PRND command is in
a position other than P the vehicle can
move abruptly, resulting in serious injury
or death.
157) Switching off the engine during
driving may cause loss of power support
for brake and steering systems. Assistance
systems and airbag systems are disabled.
Lighting and brake lights will extinguish.
Therefore power down the engine and
ignition while driving only when required
in case of emergency.
IMPORTANT
48) When the engine is switched off never
leave the ignition device in the ENGINE
position to prevent useless current