Page 16 of 28
Technical Support
1 866 228-3762
Systems Engineer
321-243-0600
9.
Turn Laser On
If testing an Optical link, select the Laser tab in the lower part of the
screen and press
Laser Off
. The button will turn Yellow and be
relabeled to indicate the
Laser
is
On
.
10.
Check LEDs
Press the
Restart
soft key on the Right side of the display to reset test
results. A
Green
Signal Present LED indicates that the T-BERD is
receiving an optical signal from the near end Ethernet Switch.
Green
Sync Acquired
and
Link Active
LEDs indicate that the T-BERD has
successfully connected to the near end Ethernet switch and the Ethernet
link is active.
11.
Check ARP Status
If you are running a
Layer 3 IPv4 Test
, verify that the final message in
the Message bar is “ARP Successful. Destination MAC obtained.” If
the message bar displays: “Messages logged,” tap the down arrow next
to “Messages logged” and verify that the final message is “ARP
Successful. Destination MAC obtained.” Click OK to exit the log.
If “
ARP Successful”
is not displayed, verify that the T-BERD’s IP menu
is configured correctly, as outlined above.
12.
Test
Inform the A-side technician that you are ready for test.
