JDS Uniphase SWS15100, Руководство пользователя

Страница: 42 / 251

Getting Started – 27
To install the source optics module and the tunable laser source in the transmitter cabinet:
1. Using the hardware provided, install the tunable laser source in the lower opening in the
transmitter cabinet, as shown in Figure 3.
2. Lift the connector cover on the laser source. The cover is marked by the laser warning sign
and shields the output port. Connect the FC/APC end of the 2 m FC/PC-FC/APC PM fiber to
the Optical Output port on the laser. The green sheath on the end of the fiber signifies an
FC/APC connector. This green connector goes into the laser input.
3. Route the PM fiber through the left-most grommet in the lower fiber-routing panel. Push the
fiber through the rightmost grommet and out to the front of the panel.
4. Using the hardware provided, install the SOM above this panel.
5. Connect the PC end of the 2 m FC/PC-FC/APC PM fiber to the Laser In port on the front of
the SOM.
6. Using the 0.5 m FC/PC jumper, connect one end to the Signal Cond. In port and the other
end into the Signal Cond. Out port, both of which are at the front of the SOM. The space
above the laser source, behind the fiber-routing panel, can be used to stow the jumper.
7. Using the 9-pin RS232 serial cable, connect one end to the RS232 input at the back of the
laser source. Connect the other end to the Aux. 1 port at the back of the SOM.
8. Connect one of the supplied universal power cords to the back of the SOM and plug the other
end into the universal power bar in the transmitter cabinet.
9. Connect a universal power cord to the back of the laser source and plug the other end into
the power bar.
10. Plug the power cord, supplied with the system, into the power bar in the transmitter cabinet
and the other end into an AC power source.
11. Clean and connect the FC/PC connector on the 10 m FC/PC-FC/APC jumper to one of the
output ports on the SOM.
12. Route this fiber to the outside through either fiber-routing panel to the back of the transmitter
cabinet. The fiber can be taken out of the cabinet either through the grommet holes at the top
or the opening at the bottom.
13. Repeat the previous step for all required outputs.
14. Turn on the power bar. Reset the breaker on the power bar.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com