![background image](http://html2.mh-extra.com/html/jcm/wba-series/wba-series_operation-and-maintenance-manual_3549776037.webp)
JCM Part No. 960-000076R_Rev. 1
© 2007, JCM-American Corporation
4 - 5
Disassembly/Reassembly
World Bill Acceptor (WBA®-1x/2x -SS & SS2)
Section 4
Stacker Motor Removal
Perform the following steps to remove the WBA
Transport’s Stack Motor:
1. Insert a screwdriver into the notch of the
Stack Motor Encoder blade and remove the
motor’s two (2) mounting screws
(See Figure 4-17 a).
2. Unplug and remove the motor from the
Transport Encoder Sensor Board
Removal
Perform the following steps to remove the WBA
Transport’s Encoder Sensor Board:
3. Remove the single (1) Encoder Sensor Board
mounting screw (See Figure 4-18 a), pull the
Encoder Sensor Board out away from the
Transport Assembly (See Figure 4-18 b) and
4. Disconnect the harness plug from the
Encoder Sensor Board to remove it from the
assembly (See Figure 4-18 c).
Transport Drive Motor Removal
Perform the following steps to remove the WBA
Transport’s Drive Motor:
1. Insert a screwdriver into the notch of the
Drive Motor Encoder blade and remove the
motor’s two (2) mounting screws
(See Figure 4-19 a).
2. Unplug and remove the motor from the
assembly (See Figure 4-19 b).
Entrance Lever Sensor Board Removal
Perform the following steps to remove the WBA
Entrance Lever Sensor Board:
3. Remove the single (1) Lever Sensor Board
mounting screw (See Figure 4-20 a), pull the
Lever Sensor Board out away from the
Transport Assembly (See Figure 4-20 b) and
a)
b)
Figure 4-16
Stack Encoder Sensor Board
Removal
a)
b)
a)
Figure 4-17
Transport Stack Motor Removal
a)
b)
c)
Figure 4-18
Transport Encoder Sensor Board
Removal
a)
b)
a)
Figure 4-19
Transport Drive Motor Removal